Club Car V-GLIDE Maintenance Service Supplement page 89

36-volt electric vehicles
Table of Contents

Advertisement

TRANSAXLE (TYPE G)
5. If using a chain hoist, lower the vehicle while guiding the leaf springs into the rear spring shackles. If using
a floor jack, raise the differential while guiding the leaf springs into the rear spring shackles. Then raise
the jack stands to support the transaxle.
6. Connect the four motor wires. Tighten the retaining nuts to 65 in-lb (7.3 N·m). Use two wrenches to pre-
vent the posts from turning. See following NOTE.
NOTE: If the motor wires were not tagged when disconnected, refer to the wiring diagram for proper con-
nection. See Wiring Diagram, Section 11, Page 11-4.
7. Insert bolts through the spring shackles and bushings in the leaf spring eyes. Secure bolts with lock nuts.
Tighten to 15 ft-lb (20.3 N·m).
8. Connect the brake cables.
9. Install the shock absorbers. Tighten shock absorber retaining nuts until the rubber bushings expand to
the same size as the cup washers.
10. Install the rear wheels and finger-tighten the lug nuts.
11. Lift the vehicle and remove the jack stands.
12. Lower vehicle and tighten the lug nuts, using a crisscross pattern, to 55 ft-lb (74.6 N·m).
13. Test drive the vehicle to check for proper operation.
2004 V-Glide 36-Volt Electric Vehicle Maintenance and Service Supplement
16A
Transaxle Installation
Page 16a-11

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents