Club Car V-GLIDE Maintenance Service Supplement page 29

ELECTRICAL SYSTEM AND TESTING
3. Make sure all the contacts are tight and the V-Glide wiper switch housing is not melted or burned around
the contacts. If the housing or fixed contacts are damaged, the entire wiper switch housing with contacts
must be replaced.
4. Make sure nuts attaching wires to the backs of the fixed contacts are tightened to 40 in-lb (4.5 N·m).
Wiper arm brush and fixed contacts
should seat firmly against each other.
WIPER
FIXED
ARM
CONTACT
BRUSH
RIGHT
Figure 11-21 Wiper Arm Brush and Fixed Contacts
WRONG WRONG
2004 V-Glide 36-Volt Electric Vehicle Maintenance and Service Supplement
WIPER ARM BRUSH
WEAR LIMIT LINE
SIDE VIEW
WIPER ARM
BRUSH
Figure 11-22 Wiper Arm Brush Wear Limit Line
11
Test Procedures
Page 11-17