Club Car V-GLIDE Maintenance Service Supplement page 43

ELECTRICAL COMPONENTS
5. Connect the 6-gauge white wire from the resistor coil and the 6-gauge white wire from the solenoid to the
bolt (9) in the wiper switch housing (Figure 12-10, Page 12-13). Install the lock washer (31) and nut (30)
onto the bolt and tighten to 40 in-lb (4.5 N·m). Install cap protector (25) (Figure 12-9, Page 12-10).
6. Connect the 6-gauge orange wire to the fourth contact from the bottom and tighten the nut to 40 in-lb (4.5
N·m) (Figure 12-10, Page 12-13). See following NOTE.
NOTE: The first three contacts have NO wires attached to them.
7. Connect the 6-gauge yellow wire to the fifth contact from the bottom and tighten the nut to 40 in-lb
(4.5 N·m).
8. Connect the 6-gauge green wire to the sixth contact from the bottom and tighten the nut to 40 in-lb
(4.5 N·m).
9. Connect the 6-gauge blue wire to the seventh contact from the bottom and tighten nut to 40 in-lb
(4.5 N·m).
10. Connect the 6-gauge black wire to the eighth contact from the bottom and tighten the nut to 40 in-lb (4.5
N·m). See following WARNING and CAUTION.
∆
WARNING
• Make sure wires are connected to V-Glide wiper switch contacts exactly as stated. If they are
not, the vehicle could start in a speed other than first.
CAUTION
• Do not operate vehicle without V-Glide wiper switch cover in place. Operating vehicle without
the cover allows dirt, dust, and water to contaminate wiper switch, which could cause switch
to fail or malfunction.
BLACK
BLUE
GREEN
YELLOW
ORANGE
WHITE
Figure 12-10 V-Glide Wiper Switch Wires
11. Make sure the wiper switch and pedal group are properly adjusted. See Section 5 – Accelerator and
Brake Pedal Group in the DS Golf Car Maintenance and Service Manual. See also WARNING on
page 12-9.
2004 V-Glide 36-Volt Electric Vehicle Maintenance and Service Supplement
BLACK
GREEN
12
Wiper Switch
Page 12-13