Removing Gateway Information From A Dimmer - Crestron CLW-DIM1 Operation Manual

infiNET™ Dimmers
8 • infiNET Dimmers: Crestron CLW-DIM1/4RF, -DIMS1/4RF, -SLVD1RF
Crestron CLW-DIM1/4RF, -DIMS1/4RF, -SLVD1RF
NOTE: The LED can flash HIGH or LOW. Refer to "LED Behavior" on
page 11 for more information.
NOTE: Holding the button for a significant time after the first flash may
enter other modes. If this is not desired, return the mode selection switch to
the "OFF" position without releasing the button and repeat step 2.
After approximately ten seconds, the LED will start to blink slowly and the
dimmer will attempt to acquire with a C2N-MNETGW that is in the
Acquire mode. The device is acquired when the LED stops blinking and
lights at the LOW setting. After being acquired, the device will exit the
Acquire mode.
The dimmer will be acquired on the C2N-MNETGW with an MNET ID
value of 01.
3. Take the C2N-MNETGW out of the Acquire mode once all devices have
been acquired. Refer to the latest revision of the C2N-MNETGW
Operations Guide (Doc. 6137), which is available from the Crestron
website.
To communicate with the control system program, an MNET ID value
between 03 and 20 must be assigned to the dimmer. For information on
assigning MNET ID values, refer to "Identity Code" on page 12.

Removing Gateway Information from a Dimmer

In some rare cases, it might be desirable to release a dimmer from a gateway. If a
dimmer is to be released from a gateway, the gateway information must be cleared
from the dimmer's memory.
To clear a dimmers gateway information:
1. Move the mode selection switch (located under the LED) to the "OFF"
position.
2. Press and hold the top or bottom of the button on the -DIM1RF/-DIMS1RF
or any button on the -DIM4RF/-DIMS4RF.
3. While holding the button, slide the mode selection switch to the "RUN"
position.
4. Hold the button for approximately ten seconds until the LED flashes twice.
Immediately release the button after the LED flashes twice to clear the
dimmers gateway information. Reacquire the dimmer if desired.
A dimmer can also be released from a gateway using Toolbox. Refer to the latest
revision of the C2N-MNETGW Operations Guide (Doc. 6137) for instructions.
Operations Guide - DOC. 6396