Recommended Rf Connector For Antenna Installation - Quectel SC200L-EM Hardware Design

GNSS

6.4.2 Recommended RF Connector for Antenna Installation

If an RF connector is used for antenna connection, it is recommended to use the U.FL-R-SMT connector
provided by HIROSE.
Figure 31: Dimensions of the U.FL-R-SMT Connector (Unit: mm)
U.FL-LP serial connectors listed in the following figure can be used to match the U.FL-R-SMT.
SC200L_Hardware_Design
Polarization Type: Vertical
Insertion Loss: < 1dB
Frequency range: 1559MHz~1609MHz
Polarization: RHCP or linear
VSWR: < 2 (Typ.)
Passive Antenna Gain: > 0dBi
Active Antenna Noise Figure: < 1.5dB
Active Antenna Total Gain: < 17dBi (Typ.)
SC200L Hardware Design
68 / 103