O Connector; Connection Of I/O Cable; Connection Of I/O Port - Advantech EDGE ER75i v2 User Manual

5.7.9 I/O Port
Panel socket 3- pin.
Pin Signal mark
1 BIN0
2 GND
3 OUT0
I/O user interface is designed for processing of binary input and control (setting) binary
output. Binary output is not switched to ground in the default configuration. Maximum load
binary output is 30 V / 100 mA. The constant current supplied by the binary input is 3 mA.
Connect I/O cable into the I/O connector on the front panel of the router and tighten locking
screws (see the figure below).
LUCOM GmbH — Flößaustr. 22a — 90763 Fürth — Tel.: +49 911/ 957 606 00 — E-Mail: info@lucom.de — www.lucom.de
Description
Binary input
Signal ground
Binary output
Table 13: Connection of I/O port
Figure 29: I/O connector
Figure 30: Connection of I/O cable
23
ER75i v2
Data flow direction
Input
Output