Ethernet Connector; Connection Of Ethernet Cable; Connection Of Ethernet Connector - Advantech EDGE ER75i v2 User Manual

5.7.5 Ethernet Port ETH
The panel socket RJ45 is used for this interface. The isolation barrier of the Ethernet signal
ports against the ground is 1500 V.
Pin Signal mark
1 TXD+
2 TXD-
3 RXD+
4 —
5 —
6 RXD-
7 —
8 —
ETH port is not PoE (Power over Ethernet) compatible!
Plug Ethernet cable into the RJ45 connector labeled as ETH (see the figure below).
LUCOM GmbH — Flößaustr. 22a — 90763 Fürth — Tel.: +49 911/ 957 606 00 — E-Mail: info@lucom.de — www.lucom.de
Description
Transmit Data – positive pole
Transmit Data – negative pole
Receive Data – positive pole
—
—
Receive Data – negative pole
—
—
Table 11: Connection of Ethernet connector
Figure 24: Ethernet connector
Figure 25: Connection of ethernet cable
20
ER75i v2
Data flow direction
Input/Output
Input/Output
Input/Output
Input/Output