Assign Privileges To Groups; Remove Groups; Show Protected Groups - GE Definium AMX 700 Operator's Manual

NOTE: Remember the following when creating group names:
– Group names cannot have spaces or uppercase (capital) letters. Use all lowercase letters in
the group name and use underscores to separate words.
– The group name must be unique. That is, the system will not allow two groups to have the
same name.
4. Click [ADD LOCAL GROUP] or [ADD ENTERPRISE GROUP] as appropriate.
The new group name is added to the table.
If the group name cannot be used you will receive a message that informs you of the problem.
Type the correct information and click [SUBMIT] again.

Assign Privileges to Groups

1. Click a group name to select it.
2. Select the checkbox under the privilege heading. Refer to
Users (p. B-2) for definitions of privileges.
NOTE: The Service privilege is protected and cannot be selected. Only GE Service personnel can assign a
group to the Service privilege.
3. Click on a selected checkbox to remove the privilege.
NOTE: You may select or deselect privileges for multiple groups.
4. Click [APPLY GROUP SETTINGS].
A message appears: "Apply group settings."
5. Click [APPLY NOW].

Remove Groups

1. Click a group name to select it.
NOTE: You are able to only delete one group at a time.
2. Click [REMOVE GROUP].
A message appears: "Remove Group (name)?"
3. Click [REMOVE NOW].

Show Protected Groups

There is a class of groups identified as protected groups. The privileges assigned to these groups can
only be modified by a GE Service Engineer.
Select the Show Protected Groups checkbox to see these groups. Protected groups and privileges are
shown with a violet (light purple) background.
Definium AMX 700 X-Ray System
Operator Manual
5161515-1EN Rev. 6 (10 February 2008)
© 2008 General Electric Company. All rights reserved.
Appendix B: Login Administration
Understanding Privileges, Groups, and
B-5