XCMG XE17U Instruction Manual page 100

1.
Before shutdown, run the engine under idle speed for 3-5 minutes to prevent
damage to the engine due to heat accumulation.
Idling helps cooling down faster.
1. Park the machine on a firm, flat ground.
2. Lower the equipment (bucket, arm and boom) to the ground and make sure that all
control levers are in neutral position.
3. Pull up the safety lever to set it to the "locked" position.
4. Set the engine speed control lever to "idle speed" position and leave the engine
running idle for 3-5 minutes.
5. Turn the key switch to "O" position to shut off the engine.
6. Turn the key switch back to "I" position to turn on the power without starting up.
7. Push the safety rod down to set it to "unlocked" position.
8. Move each of the control levers around to release residual pressure of the hydraulic
machine.
9. ull the safety lever up again on the "locked" position.
10. Turn the key switch back to "O" position to shut off the engine.
11. Pull out the key.
Note:
1. When the engine is shut off, excavator and equipment (bucket, arm and boom) or
attachments must be set according to the parking requirements, in case that the
devices will fall and hurt machine or people because of sliding or slow action.
2. When the machine is parked for a short time, check the parking area before parking,
make sure the exposed people will not be hurt if the equipment (bucket, arm and
boom) and attachments fall or move on its own.
Confirm checks after shutdown
1. If coolant or oil leaks, fasten them, or if still leaking, contact skilled personel.
2. Check the equipment (bucket, arm and boom) and the undercarriage for anomalies
and/or troubleshooting
3. Refuel.
4. Remove combustible materials accumulated in engine portion, such as tree leaves,
wood sticks or paper.
5. Clear the mud out of the crawler's and the machine's bottom.Keep all pedals and
levers clean inside the cabin.
09.2020 Seite 90 / 197