13)Preheating indicator(s)
When the ambient temperature is low (below 0 ℃), the engine ECU automatically
–
controls the preheating of the engine, and a indicator will appear in the display.
14) Battery (charge) fault code
–
The monitor shows A501 if:
The generator does not charge the battery.
o
The monitor display fails to indicate the charging.
o
Check both of them, and have them repaired if necessary.
o
15) Display monitor
–
Shows all important status information of the excavator
–
Also shows all abnormalities and the related warnings indicating their occurance
–
The indicators on the display also light up or flash when abnormalities happen
16)Fuel stock indicator
–
When the fuel level is less than 10%, the indicator on the display flash and the
fault code "A302" starts to flash at the same time.
17) Coolant temperature indicator
–
When the coolant tempereture is more than 105℃, the indicator on the display
flash and the fault code "A301" appear in the fault code area.
18) Aux mode indicator
–
The indicator lights up according to the mode of the auxiliary implement.
19) Spare power
–
The spare power supply used the cigarette lighter in the cabin.
–
Confirm whether the device's operating voltage matches the machine voltage
before use.
–
Using this device with excessive power may cause the fuse to blow.
–
Unplug the device to overhaul the fuse in case of a function failure.
20) CAN fault code
–
When the fault code "E4030" appear in the fault code area, the CANbus faults and
contact the skilled personel immediately.
09.2020
A501
A302
A301
A4030
Seite 76 / 197