XCMG XE17U Instruction Manual page 184

Magnetic vibration of
starting motor
The starting motor
rotates but it can't be
started.
Slow starting of engine
The engine bleeds
white gas.
Large noise or vibration
of turbo charger
Oil dripping of turbo
charger joint
Too large resistance of
turbo charger rotating
member
09.2020
Poor connection of battery or
starting motor circuit
Low capacity of battery
Opening of starting motor
magnetic "hold" coil
Disengagement of starting
motor pinion with the flywheel
gear
Seizure or trouble of pinion
shift mechanism
Fracture of pinion teeth
Fracture of flywheel gear
teeth
Inner damages or fracture of
battery leads
Loosening of battery or
starting motor connection or
corrosion
Wrong fuel.
Low temperature of engine
Trouble or overcooling of
thermostat
Off-time of injection pump
Leak of cooling water into the
cylinder of engine
Bearing is not lubricated.
Worn bearing
Air leaks of engine, suction or
drain pipe
Improper gap between the
turbine and turbine case
Breakage of turbine blade
Damage or wear of bearing
and (or) worn seal
Overhigh pressure of
crankcase
Blockage of turbo charger
return pipe at the exhaust
pipe
The combustion deposits
cause the blockage of coal
behind the turbine.
Leaks of air suction pipe
cause the blockage of dirt
behind the compressor wheel.
Clean the connection part.
Charge or replace battery
Contact with the assigned dealer of XCMG.
Contact with the assigned dealer of XCMG.
Contact with the assigned dealer of XCMG.
Contact with the assigned dealer of XCMG.
Contact with the assigned dealer of XCMG.
Check and replace the leads.
Clean and tighten the connection.
Empty the oil tank, and adopt the correct fuel.
Run the engine until it becomes hot.
Contact with the assigned dealer of XCMG.
Contact with the assigned dealer of XCMG.
Contact with the assigned dealer of XCMG.
Insufficient oil pressure, check the blocked oil
pipe of turbo charger
Contact with your assigned dealer.
Check or repair.
Contact with the assigned dealer of XCMG.
Remove the exhaust elbow and air inlet hose,
and check them.
Contact with the assigned dealer of XCMG,
check and clean the air filter, check if the
service interval of engine is proper or dirt enters
into the engine.
Check the vent pipe, ensure the pipe is not
blocked, and clean it.
Remove the pipe, and check or clean it.
check or clean
check or clean
Seite 174 / 197