Use Preparation After Storage - XCMG XE17U Instruction Manual

Notice!
8.7

Use preparation after storage

Notice!
09.2020
– Check the machine, repair the worn and damaged parts. If necessary, attach
new parts.
– Clean the air filter element.
– If possible, retract all the hydraulic cylinders; if impossible, apply the grease to
the exposed rod of hydraulic cylinder.
– Lubricate all the lubrication points.
– Place the track on the long and stable damp block.
– Clean the machine.
– After charging the battery up, remove the battery and store it at dry and safe
place. If not, separate the connection of battery negative-pole cable on the
wiring terminal (-).
– Add the anti-rust agent into engine coolant. In winter, adopt the anti-freezing
agent or drain the coolant off. If the cooling system is emptied, be sure to
hang a nameplate "No Water of Radiator" in conspicuous position.
– Loosen the belts of AC generator and cooling fan.
– Apply the paint to desired positions to avoid rusting.
– Store the machine at dry and safe place. In case of storing it outdoor, adopt
the water shield.
Long-term storage and protection
Storage place
– Commonly store in the ventilated and dry warehouse.
– If the device is stored in open air, park it on the concrete ground easy to drain
the water, cover and fix the canvas or hood, and store it at the place that can't
be invaded by natural disaster and without corrosive or harmful substance or
gas.
Storage
– Use the hydraulic functions of moving, rotation and digging twice to three
times every month to lubricate all the parts. Check the level of coolant and
lubrication state before the operation.
– Check the appearance quality, protection side and anti-corrosion substances,
and etc at regular intervals.
Use preparation after storage
– Remove the coverings.
– Remove the protective substances painted on the exposed part.
– Charge the battery, mount or connect it.
– After draining the oil of engine crankcase, renew the oil.
– After draining the gear oil in the rotary and traction reducer, renew the
gear oil.
– Drain the inclusions and mixed water out of the hydraulic oil tank and fuel
tank.
– Apply the grease to each hinged position.
– Fill in the coolant as per the specification.
– For the check before the operation, refer to the relevant regulations of
operation.
Seite 187 / 197