XCMG XE17U Instruction Manual page 145

Notice!
09.2020
– Check whether the soleplate of the protection device is rusted or
damaged. If any, please contact the distributor appointed by XCMG
and let the authorized professionals to do the repair.
– Equip appropriate hoisting tools to take down the original protection
device carefully and save it safe or hand it over to some specially
assigned person.
– Install the new undamaged protection device carefully and tighten
up the fasteners with necessary tools.
– Never operate the excavator without the protective structure.
Modification without approval
– Any modification without approval from Xuzhou XCMG Excavator
Mechanical Co., Ltd. is possible to cause danger. Therefore, before
modifying, please contact the distributor of XCMG.
– For any injury, accident or product fault caused by modification
without approval from XCMG, the company will not bear any
responsibility.
Removal of counterweights and front-end equipment
– Warning: Removal of counterweights or front-end equipment or any
other component from the machine will affect its stability and this will
result in its sudden move causing serious injury and death.
– You can remove counterweights or front-end equipment only when the
top structure and the bottom structure are disposed of in the same
direction. Once counterweights or front-end equipment is removed, do
not rotate the top structure
Safety in the workplace
– Before operating, check the work area thoroughly for dangers.
– When operating near the flammable materials (cottage roof, dry leaves
or grasses) stored, it is possible to cause a fire, so it is necessary to be
careful during operating.
– Check the ground situation in the workplace and finalize the safest
operation method. It is forbidden to operate in the place with collapses
or falling stones.
– If there are water pipes, gas pipes or high voltage electrical wires
buried under the workplace, please contact the related companies and
mark their positions, note: do not break or damage any pipe and wire.
– It is forbidden for any unauthorized person to enter the working area,
some necessary warning measures should be taken.
– Before moving or operating in the shallow water or on the soft ground,
check the types and situation of the sill and the depth and the flow rate
of the water.
Seite 135 / 197