XCMG XE17U Instruction Manual page 137

Notice
Notice
Notice
Notice
09.2020
The machine parts assembled with bearings (e.g.: bucket, knapper,
grafter) may suddenly loosen up and fall, causing serious injuries to
unawared people nearby.
To prevent this hazard, always disassemble and store the
interchangeable equipment if it is not used for a longer period of time
safely to avoid falling, so the children and other personnel should be far
away from the storage
Pay attention to hot fluids
–
Avoid burns caused by sprayed high-temperature fluid. After the
operation, the engine's cooling water is hot and pressurised.There is hot
water or steam inside the engine or the radiator, too. If the skin contacts
the spilled hot water or steam, the severe skin burns will be caused.
–
Prevent burns from hot water. Do not open the cover of radiator before
the engine has cooled down. When opening the cover, turn the cover to
bottom slowly, and remove the cover after the pressure is completely
released.
–
Pressure exists in the hydraulic oil tank. Ensure that the pressure is
released before removing the cover.
–
High-temperature fluid and surface. During the operation, engine oil, gear
oil and hydraulic oil may become hot; engine, hose, pipe and other parts
will also become hot.
–
After the oil and parts cooled, start to check or maintain them.
Periodic replacement of rubber hose
– Due to ageing, fatigue and wear, the rubber hose containing flammable
fluid may be broken under the pressure. It's difficult to judge the poorness
of rubber hose due to its ageing and wear and replace the rubber hose at
regular intervals.
– Irregular replacement of rubber hose may cause the fire, the injection of
fluid into skin or the knock of working device to persons around it will
cause severe heat injury, dermal gangrene, other injuries or death.
Pay attention to high-pressure fluid
– If the fuel, hydraulic oil or other fluids injected under high pressure can
penetrate the skin or rip into the eyes, it will cause severe injury,
blindness or death.
o Release the pressure before removing the hydraulic or other pipes to
avoid this risk.
o Fasten all connections before repressurizing.
o Use cardboard to find leaks, and protect your hands and body from
high-pressure liquids. Wear the face mask or safety goggles to
protect your eyes.
o In case of any accident, let the doctor who's familiar with this type of
wound cure immediately.
– Any fluid injected into skin must be removed through surgery within
several hours, otherwise the dermal gangrene will be caused.
Treatment of accumulator
area.
Seite 127 / 197