Precautions For Installation - ISHIDA IP-EMZ Manual

1.5

PRECAUTIONS FOR INSTALLATION

1.5.1 GENERAL PRECAUTIONS
DO NOT PUT HANDS IN THE MACHINE
When you need to put your hand inside the machine, always push the Emergency Stop Button first.
Never put your hand inside the machine.
ALWAYS KEEP HANDS AWAY FROM THE MOVING PARTS
When the power is turned ON, some parts may still move after a commodity or tray has been called,
and your hand may get caught in the machine.
DO NOT PUT YOUR HAND INSIDE THE POWER SUPPLY UNIT
There is danger of electric shock if you touch the inside of the Power Supply Unit. Never touch
directly or spill water into the unit. Also, never touch the Main Power Switch with wet hands.
DO NOT DISASSEMBLE OR MAKE ANY ALTERATIONS TO THE MACHINE
The machine can be damaged if disassembled incorrectly. Making any alterations without
permission, or removing any parts other than those specified, may cause a serious accident or
injury.
HANDLE WITH CARE AS THIS IS A PRECISION MACHINE
Bumps or shocks to the machine can cause damage.
1.5.2 MAINTENANCE PRECAUTIONS
• Keep the area around the machine clear of any dust and
• Do not leave screws or other foreign objects in the machine after performing routine maintenance
since this can cause major damage to the machine when the electrical switch is turned on.
• Always remove wires by holding the connector and pulling to disconnect.
Do not disconnect by pulling on the wires themselves since this may cause a wire to snap or
damage the connection.
• Before disassembling or adjusting this machine, make sure you thoroughly understand and follow
each step in the order indicated in this manual.
1.5.3 PROHIBITED LOCATIONS
• Places subject to high temperatures or high humidity
• Places exposed to direct sunlight
• Places where water or other liquids are easily spilled on the machine
• Places subject to excessive vibration or unstable foundations
• Places exposed to direct cold air from air conditioners or refrigerators
• Places where the floor or foundation is unstable
• Places subject to a lot of dust or dirt
• Places with large voltage fluctuations
1.5.4 PRECAUTIONS FOR POWER SUPPLY
• Use a power supply with rated voltage ground.
• Prepare a dedicated power source.
A power supply that generates voltage variation may cause a malfunction.
• To avoid any potential electrical shock, securely attach the ground wire to the grounding provision.
IP-EMZ Operation Manual
Do not install the machine in the following types of places:
Do not use an unspecified power supply.
Chapter 1 INSTALLATION
debris.
1-7