Setting Up The Serial Port - GE XDP-H2 User Manual

Setting Up the Serial Port

Setup and Calibration
After entering the User Program, as described on page 3-4, the main
menu appears. To set up the serial port, proceed as follows:
Note: For the XDP, the serial port is normally used only for
downloading software upgrades to the meter.
Cal Opt Disp
Cal Opt Disp
User
Lock Menus
Note: "Lock All" and "Versions" menu options also appear on the
above list.
User
Contrast
Backlight
Comm
Note: The "Fault Alarm" and "Analog Output" options are also
available in the above list box.
IMPORTANT:
Each of the following prompts shows the usual
default value for that parameter.
At the following prompt, choose one of the following numbers as the
Node ID for the meter: 16, 32, 48, 64, 80, 96, 112, 128, 144, 160, 176,
192, 208, 224, or 240.
User Node-ID
Node ID
s
16 t
January 2008
Use the [ ] and [ ] keys to
[Opt] [ENTER]
select and press
Use the [ ] and [ ] keys to
[User] [ENTER]
select and press
Use the [ ] and [ ] keys to
[Comm]
select and press
[ENTER]
.
Use the [ ] and [ ] keys to
scroll the list of available node
ID numbers. When the desired
number is highlighted, press
[ENTER]
.
.
.
4-15