GE Multilin EPM 6000 Instruction Manual page 67

CHAPTER 4: USING THE METER
EPM 6000 MULTI-FUNCTION POWER METERING SYSTEM – USER GUIDE
Select "rtU" for Modbus RTU, "ASCI" for Modbus ASCII, and "dnP" for
the DNP 3.0 protocol.
• The first screen is meter address (
POrt
screen.
Select three-digit number for the address.
Refer to Programming the Configuration Mode Screens on page 4–
10 for details on changing values.
• The next screen is the baud rate (
POrt
on the "B" screen. Refer to Programming the Configuration Mode Screens on page
4–10 for details on changing values. The possible baud rate screens are shown
below.
• The final screen is the communications protocol (
POrt
The current protocol is displayed on the "B" screen.
Refer to Programming the Configuration Mode Screens on page 4–10 for details on
changing values. The three protocol selections are shown below.
). The current address appears on the
Adr
Address 005
). The current baud rate is displayed
bAUd
Prot
).
4–15