Advertisement
10
www.raider.bg
The warranty will become void if this appliance is used in commercial or industrial enterprises and equivalent applications.
2.1. Before work
Replacing / Placing the Knife
3. Open chuck by turning it fully counterclockwise (Figure 1). This will pick up the pin and you can insert the knife.
3.1. Place the knife in the chuck (3a) and push until it stops, then tighten the chuck (3b).
3.2. Gently pull the knife to make sure it is firmly attached.
Always pull the blade to make sure it is firmly held in the chuck. Failure to do so may result in serious injury.
4. Adjust the guide driver
4.1. Loosen the cap screw with hexagonal key.
4.2.Tap the driver through the two screws under the cover
WARNING! Do not work with the saw if the driver is not installed and
installed correctly.
Advertisement
