Table of Contents
Advertisement
GE Consumer & Industrial
Multilin
DGT Distributed Generation Trip
Control System
Chapter 3: User interface
Transceiver layouts
DGT DISTRIBUTED GENERATION TRIP CONTROL SYSTEM – INSTRUCTION MANUAL
User interface
DGT-U Transceiver layout
TERMINATIONS
LED PANEL
Power, Link, Inputs/Outputs
◆
(configurations vary)
RF OUTPUT
Antenna Connector (TNC)
◆
902 to 928 MHz (FHSS)
◆
•
Power LED shall illuminate when power is applied to the radio.
•
The Link LED illuminates when the DGT-D transceiver has established a connection
with a DGT-R transceiver.
•
The Service (SERV) LED flashes whenever a transceiver alarm condition is detected or
if any of the configured outputs are in a failsafe state.
•
The input LED (IN) is illuminated whenever the trip status is energized.
•
The output LED (OUT-1) illuminates whenever the associated output is energized.
OUT-1 will reflect the state of the status input on the DGT-D radio configured for Slot 1
PRIMARY POWER
13.8 Vdc @ 350 mA (6 to 30 Vdc)
◆
Negative Ground
◆
1 + / 2
◆
+
+
1 to 4
24 VDC POWER OUTPUT
5 to 8
24.0 Vdc @ 40 mA
◆
Isolated from Ground
◆
Pins 3 (+) and 4 (-)
◆
PWR
LINK
SERV
IN
OUT-1
OUT-2
OUT-3
OUT-4
OUT-5
OUT-6
CONFIGURATION
OUT-7
ÊDCE Console/Terminal
◆
19,200 bps/8N1 (Default)
◆
CONFIG
No Handshaking
◆
RS/EIA-232
◆
ANT
TERMINATIONS
9 to 12
13 to 16
-
3–19
Advertisement
Table of Contents
