Table of Contents
Advertisement
ENERVISTA DGT-UTILITY SETUP SOFTWARE
NOTE:
NOTE
4–44
7.
Use the Quick Connect button, located just above the Online window, to "find" each of
the DGT units (DGT-U, DGT-R, and DGT-D) to which you are connected. Each DGT unit
is connected to your COM port using a single removable cable. Select the appropriate
COM port and press the Connect button.
Information on all connected DGT units will appear in the online window as shown below:
As we can see, the type of the device is "DGT-U Primary" and the serial number is: 1729022.
If we are going to upload an auto-generated Settings File, the correct file name should be
"1_1729022.hkf" (see the previous section for details).
8.
To upload the generated Settings File to the respective device, click on Send Settings
File in the Online Menu, or select Online from the Main Menu, then select Send File to
Device.
9.
From the window that appears, select the Settings File you want to send, then click the
Open button. You will be asked to confirm the action:
DGT DISTRIBUTED GENERATION TRIP CONTROL SYSTEM – INSTRUCTION MANUAL
CHAPTER 4: SOFTWARE
Advertisement
Table of Contents
