Table of Contents
Advertisement
CHAPTER 2: INSTALLATION
DGT DISTRIBUTED GENERATION TRIP CONTROL SYSTEM – INSTRUCTION MANUAL
2.
Prepare the mounting surface for the fasteners to be used. (If using lag screws, a small
pilot hole at each mark will allow easier starting of the screw.)
3.
Insert the 4 mounting screws and tighten them securely. Do not over-tighten.
POLE MOUNTING
Standard pole mounting requires the use of two pole-mount adapters (P/N 82-1743A01).
These brackets must first be bolted to the DGT enclosure. The complete assembly can then
be mounted to a wooden utility pole with two lag screws or with two long bolts that extend
through the pole. (Threaded rod can also be used for through-the-pole mounting.) In either
case, it is important to use flat washers with the attaching hardware (fasteners are not
supplied).
To pole mount the unit, follow these instructions:
1.
Attach the two pole-mount adapter brackets to the DGT enclosure with four 10-32
screws. The screws must be no longer than 3/8" (9.5 mm). Longer screws will damage
the enclosure
2.
With the help of an assistant, position the DGT enclosure on the pole at the desired
mounting point.
3.
Install the attaching hardware (with flat washers) in the center hole of the two
brackets.
4.
Tighten the fasteners securely, but do not over-tighten.
MECHANICAL INSTALLATION
2–13
Advertisement
Table of Contents
