Resetting The Litres Per Day Counter; Setting The Switch-On And Switch-Off Point For Pressure Production; Additional Functions In The Bwt; Systems App - BWT AQA therm MOVE Power Installation And Operating Manual

7 .4 .1 Resetting the litres per day counter

Press the circle button.
f
The product is set to
Press the checkmark button.
f
The prompt
RESET ?
Press the checkmark button again.
f
The litres per day counter is set to
.
LITRES
7 .4 .2 Setting the switch-on and switch-off
point for pressure production
NOTE
Membrane cartridge wear!
The membrane cartridges are worn down quickly if the
operating times are too short (frequent starting and
stopping)
► When setting the switch-on and switch-off point for pres-
sure production, a difference of at least 1 bar must be main-
tained.
The integrated pump in the product produces the
outlet water pressure required to fill the system.
When the preset system pressure is reached, pres-
sure production stops. This pressure value is refer-
red to as the switch-off point (
If the system pressure falls to a preset value, the
pump begins to produce the outlet water pressure
.
PAUSE
appears on the display.
ZERO
).
STOP
again. This pressure value is referred to as the
switch-on point (
START
The switch-off point (
( ) for pressure production are set as follows:
START
Press the circle button.
f
The product is set to
Press and hold one of the two arrow buttons
f
for three seconds.
Press the checkmark button to switch be-
f
tween the switch-off point (
on point ( ).
START
Press the arrow buttons to increase or lower
f
the point selected earlier.
8 Additional functions in the
BWT RO systems app
To install the BWT RO systems app,
you require a scanner app on your
mobile device. Some of the scanner
apps available on the market are not
compatible.
The BWT RO systems app displays all the values
from the product display. You can set limit values
and reset the litres per day counter in the technici-
an menu in the BWT RO systems app.
The BWT RO systems app is connected to the
product via Bluetooth.
).
) and switch-on point
STOP
.
PAUSE
) and switch-
STOP
EN
43