Setting The Conductivity Value For The Outlet Water - BWT AQA therm MOVE Power Installation And Operating Manual

16
17
You can find the specifications for the current and
voltage supply in the technical data (see chapter
„17 Technical data", Seite 54).
6 .5 Setting the conductivity value for
the outlet water
For certain types of use of the AQA therm MOVE
Power, you can manually set a specific conductivi-
ty value for the outlet water.
The following conditions must be met:
DAll the product components are fully installed.
DThe electrical and hydraulic systems for the
product are connected
DANGER!
High voltage!
Risk of death by electric shock!
► Disconnect the product from the power supply
before all maintenance and repair work.
► There may still be voltage from external con-
nections even when the mains voltage is dis-
connected.
► Discharge live components through earthing.
Before making a manual setting,
check the conductivity of the outlet wa-
ter on the product display (see chapter
„7.3 View and settings on the product
display", Seite 42).
You set the desired conductivity value for the outlet
water by turning the blending ring on the filter head:
1. Switch off the product on the main power
switch and disconnect the mains plug.
2. Remove the four screws [18] on the cover
panel of the product and remove the cover
panel.
18
Set the blending ring for both filter
heads to the same position.
3. Hold down the button [19] on the filter head
and turn the blending ring [20] to the desired
position in the direction of the arrow [21].
(In position "0" [22], no outlet water is blend-
ed. Turning the blending ring in the direction
of the arrow increases the blending of the
outlet water).
4. Close the product again using the cover
panel and fasten the cover panel using four
screws.
5. Reconnect the product to the electrical supply
and restart the product.
6. Check the conductivity value of the outlet
water on the product display (see chapter
„7.3 View and settings on the product dis-
play", Seite 42).
19
20
21
EN
22
41