Table of Contents
Advertisement
2.1.
Installation of CAN-box TV-436
The CAN interface is connected to
the backside of the OEM screen.
Remove 3 TORX screws at the OEM screen.
Remove cover grill (only plugged). Place soft
towel beneath the navigation monitor
to avoid scratches
Flip down the board monitor. NOTE: The OEM
screen gets stuck with its connector at the upper
side of the cockpit. Insert a hard plastic sheet like
a credit card to prevent cockpit from
taking damage.
Remove the black connector at the backside of
the screen as shown below.
Version 20.09.2017
C2-E65-TV
Advertisement
Table of Contents
Need help?
Do you have a question about the c.LOGiC C2-E65-TV and is the answer not in the manual?
Questions and answers