Download Print this page

Caraudio-Systems z.LiNK ZL-MFD1 Quick Start Manual

Compatible with audi navi plus and vw mfd1 navigation systems (4:3)

Advertisement

Quick Links

z.LiNK audio-video-input
ZL-MFD1
Compatible with Audi Navi Plus and VW MFD1
navigation systems (4:3)
AV-input to connect any AV-source to the factory navigation system
Version 21.05.2010

Advertisement

loading

Summary of Contents for Caraudio-Systems z.LiNK ZL-MFD1

  • Page 1 z.LiNK audio-video-input ZL-MFD1 Compatible with Audi Navi Plus and VW MFD1 navigation systems (4:3) AV-input to connect any AV-source to the factory navigation system Version 21.05.2010...
  • Page 2: Table Of Contents

    Contents 1. Prior to installation 1.1. Delivery contents 1.2. Checking the compatibility of vehicle and accessories 2. Installation 2.1. Place of installation 2.2. Removal of head unit 2.3. Connecting the interface to the navigation unit 2.4. Activation of the interface as a current AV-source 2.5.
  • Page 3: Prior To Installation

    1. Prior to installation Read the manual prior to installation. Technical knowledge is necessary for installation. The place of installation must be free of moisture and away from heat sources. 1.1. Delivery contents Take down the serial number of the interface and store this manual for support purposes: ____________________ 1.2.
  • Page 4: Installation

    2. Installation Switch off ignition and disconnect the vehicle’s battery! The interface needs a permanent 12V source. If according to factory rules disconnecting the battery is to be avoided, it is usually sufficient to put the vehicle is sleep-mode. In case the sleep-mode does not show success, disconnect the battery with a resistor lead.
  • Page 5: Connecting The Interface To The Navigation Unit

    2.3. Connecting the interface to the navigation unit • Connect Video-out of the AV-source to the interface box • Connect Audio-out of the AV-source to the cable harness Cinch-connections: YELLOW VIDEO-input (FBAS-signal) AUDIO-input right-hand side BLACK = AUDIO-input left-hand side •Connect round 10pin-connector of the cable harness to the round 10pin-female connector on the backside of the navigation...
  • Page 6: Picture Settings For The Interface

    -30°C to +80°C Weight Dimensions (box only) B x H x T 105 x 30 x 78 mm 4. Technical Support Caraudio-Systems Vertriebs GmbH manufacturer/distribution In den Fuchslöchern 3 D-67240 Bobenheim-Roxheim email support@caraudio-systems.de Legal disclaimer: Mentioned company and trademarks, as well as product names/codes are registered trademarks ®...