Tool-Button - Bosch Rexroth ErgoSpin Series Installation Instructions Manual

82/104 Bosch Rexroth AG
Operation
• If the torque threshold (basic setting: 5% of
the nominal torque of the hand-held
nutrunner) was not exceeded, there will be no
evaluation. The system interprets this process
as "Play at start switch" and ignores it.
• If the initial torque was exceeded, tightening is
evaluated as faulty (NOK) and the red LEDs
are illuminated.
If the ErgoSpin/CC-ErgoSpin hand-
held nutrunner is used as a stationary
tightening spindle, the start switch
must be continually actuated. Lock
the start switch on the ErgoSpin/CC-
ErgoSpin hand-held nutrunner using
the velcro tape.
ErgoSpin/CC-ErgoSpin | 3608870H86/2020-01
8.4 Tool button
On delivery, the tool button is con-
figured such that NOK tightening must
be acknowledged with the button.
Further tightening processes can only
be started after this
acknowledgement.
Push the tool button to acknowledge.

The function of the tool button can be changed
via the PLC assignment table (control signals) in
the operating system, e.g. BS350 or BS350 CC-
ES (until the BS350 standard with V2.400 has
been introduced).