Toro Greensmaster Flex 1800 Service Manual page 117

Wheel Removal (Fig. 21)
1. Park machine on a level surface. Make sure the en-
gine is OFF.
2. Support the machine on the kickstand.
3. Pivot wheel retaining lever away from the center of
the wheel. Slide transport wheel off the wheel hex shaft.
Wheel Disassembly (Fig. 20)
1. Make sure that tire is fully deflated before disassem-
bly of wheel.
2. Remove three (3) cap screws and lock washers from
the shallow rim and hub. Remove hub from deep rim.
3. Inspect hub bushing (item 12). If worn or damaged,
replace bushing.
4. Remove four (4) cap screws and flange nuts from the
deep rim and shallow rim. Remove shallow rim from the
deep rim.
5. Separate tire, tube and deep rim.
6. If necessary, remove shoulder screws, torsion spring
and retaining lever from the hub.
Wheel Assembly (Fig. 20)
1. If shoulder screws were removed from hub, apply
Loctite #242 (or equivalent) to threads of shoulder
screws. Secure torsion spring and retaining lever to the
hub with shoulder screws.
2. Assemble tire, tube and deep rim.
3. Install shallow rim into the tire. Align and secure shal-
low rim to the deep rim with four (4) cap screws and
flange nuts. Tighten fasteners.
4. Install hub into deep rim. Secure hub to deep rim with
three (3) cap screws and lock washers. Tighten fasten-
ers.
5. Inflate tire from 12 to 15 PSI (83 to 103 kPa).
Wheel Installation (Fig. 21)
1. Make sure machine is parked on a level surface and
the engine is OFF.
2. Support the machine on the kick stand.
3. Slide transport wheel completely onto the wheel hex
shaft until the wheel retaining lever is secured into the
groove on the wheel hex shaft.
Greensmaster Flex 1800/1820/2100/2120
1. Wheel retaining lever
Page 6 − 19
2
Figure 21
2. Wheel hex shaft
Figure 22
1. Wheel hex shaft
Chassis and Controls
1
1