Roller Service - Toro Greensmaster Flex 1800 Service Manual

Roller Service

25 to 30 ft−lb
(34 to 41 N−m)
6
7
1. Weihle roller
2. Smooth roller
3. Roller shaft
Disassembly
1. To hold roller shaft for bearing lock nut removal,
install a 3/8−24 UNF 2B screw into threaded end of roller
shaft and secure screw in place with jam nut. While re-
taining shaft, remove bearing lock nut from each end of
roller shaft.
2. Remove V−ring from each end of roller.
3. Carefully inspect seating surface and threads of
bearing lock nuts. Replace lock nut if any damage is
found.
4. Loosely secure roller assembly in bench vise and
lightly tap one end of roller shaft until seal and bearing
are removed from roller cavity. Remove second seal and
bearing from roller cavity by tapping on shaft.
5. Clean bearing cavity in roller and remove any rust
with crocus cloth.
Assembly
1. Place roller shaft into roller.
NOTE: If bearing lock nuts are being replaced, use
original lock nuts for assembly purposes, if possible.
This will preserve the patch lock feature in the new lock
nuts. Use the new nuts only after new bearings and
seals have been installed.
Cutting Unit
1
2
4
5
4. Ball bearing
5. Seal
Figure 36
1
1. Roller
2. Ball bearing
3. Seal
1. Bearing lock nut
2. Black assembly washer
Page 7 − 28 Greensmaster Flex 1800/1820/2100/2120
6
5
4
25 to 30 ft−lb
3
(34 to 41 N−m)
6. V−ring
7. Bearing lock nut
3
4
5
2
Figure 37
4. V−ring
5. Bearing lock nut
6. Roller shaft
3 1
2
Figure 38
3. Bearing
7
6