Toro Greensmaster Flex 1800 Service Manual page 195

Disassembling the Groomer Reel (continued)
Assembling the Groomer Reel
Greensmaster Flex 1800/1820/2100/2120
12188SL Rev D
4. Remove the spacers and blades from the groomer shaft. If necessary,
remove second locknut from the shaft.
5. Inspect and replace the components that are worn or damaged.
Note: New locknuts have an adhesive patch to prevent the locknut from
loosening. If a used locknut is being installed, apply a medium strength
threadlocker (Loctite #242 or equivalent) to the threads of the locknut.
1. Install the locknut on drive end of the groomer shaft. Place the groomer
blade on the groomer shaft.
2. Alternately install 11.6 mm (0.46 inch) spacers and blades, ensure that all the
blades are separated by a spacer.
3. When all the blades have been installed, install the second locknut onto the
shaft. Center the blades on shaft by adjusting locknuts.
4. Use the through holes in shaft to prevent the shaft from rotating, tighten
the second locknut to 42 to 48 N∙m (31 to 35 ft-lb). After tightening the
locknut, spacers should not be free to rotate and the groomer blades should
be centered on the shaft.
5. Install the O-ring on the non-drive end of the groomer shaft.
6. Install the groomer reel back onto the cutting unit; refer to
Groomer Reel (page 9–18).
Page 9–21 Universal Groomer (Optional): Service and Repairs
Installing the