Height Adjuster Assembly - Toro Greensmaster Flex 1800 Service Manual

Height Adjuster Assembly

Disassembling the Height Adjuster Assembly
Universal Groomer (Optional): Service and Repairs
g324624
1. Height adjuster knob
2. Carriage bolt
3. Height-of-cut bracket
4. Flange nut
5. Groomer hose
6. Washer (2 each)
7. Compression spring
Note: Early universal groomers used 2 compression springs on non-adjustable
height adjustment rods. Retrofitting the assemblies on each side of the cutting
unit with new compression springs, height adjustment rods, and adding flange
nuts to enable spring adjustment is recommended
1. Park the machine on a clean and level surface, lower the cutting units
completely to the ground, set the parking brake, and remove the key from the
key switch.
2. Remove the cotter pins and clevis pins that secure the height adjustment
rods to the groomer gear box and idler arm. Discard the cotter pins.
3. Loosen the 2 height adjustment bolts (item 15 in
4. Remove the flange nut (item 4 in
height adjuster assembly to the cutting unit side plate, and remove the front
roller and height adjuster from the cutting unit.
5. Disassemble the height adjuster assembly
6. Clean all the components and inspect for wear or damage. Replace all the
components that are worn or damaged.
Figure 12
8. Flange nut
9. Height adjustment rod
10. Groomer pin
11. Quick up lever
12. Quick up cover
13. Detent spring
14. Button-head screw
Figure 12) and carriage bolt that secure the
Page 9–22
(Figure 12).
Figure 12) and 2 locknuts.
(Figure 12).
Greensmaster Flex 1800/1820/2100/2120
12188SL Rev D