Table of Contents
Advertisement
PSEN ma1.1p-12
}
Please note the installation measures in accordance with EN ISO 14119 for a proximity
switch type 4 with coding level Low.
}
Alignment errors of the guard must not adversely affect the safety function of the guard.
}
The assured operating distance S
under real conditions.
}
Do not apply any installation tools (e.g. Pliers) on the surfaces of the switch.
}
Install safety switch and actuator
– facing each other in parallel
– so that the faces with the product names are opposite each other.
}
The protection type (see
Pilz connection leads available as an accessory.
}
If possible, do not install the safety switch and actuator on to ferromagnetic material.
Changes to the operating distances are to be expected. In this case, use the spacer (see
Order reference [
}
Safety switches and actuators should only be secured using M4 screws with a flat head
(e.g. M4 cheese-head or pan head screws). Use screws made of non-magnetic material
(e.g. brass).
Adjustment
}
The safety switch may only be used with the corresponding actuator PSEN 1.1-10.
}
Always test the function with the PSEN ix1 interface and connected evaluation device.
}
The stated operating distances (see
safety switch and actuator are installed according to the specifications
Installation [
Note the maximum permitted lateral and vertical offset (see
eral and vertical offset [
Periodic test
}
Carry out a monthly function test on the safety switch and actuator.
}
Always test the function with the PSEN ix1 interface and connected evaluation device.
}
The safety function may only be checked by qualified personnel.
Operating Manual PSEN ma1.1p-12
22190-EN-04
and the assured release distance S
ao
Technical details [
19]).
Technical details [
14]. Operating distances may deviate if other arrangements are used.
8]).
16]) can only be achieved by using the
16]) only apply when the
Operating distances and Lat-
must be tested
ar
| 15
Advertisement
Table of Contents
