10.7.8
Replacing the Compact Flash Card
Refer to the following figure when replacing the Compact Flash card (applies to NXGpro Control
ONLY).
1
Figure 10-17
Perform the following steps to replace the Compact Flash card.
1. Remove the Compact Flash card from the compact flash slot located on the NXGpro Digital
Control Rack (DCR).
2. Copy the stored data of the old card to the new original Siemens card.
3. Place the new card into the compact flash slot on the DCR.
Type 6SR5 Air-Cooled
Operating Instructions, AK, A5E39390112
Compact Flash card insertion slot
NXGpro Digital Control Rack - Compact Flash
Maintenance
10.7 Remove and Replace
85