Table of Contents
Advertisement
Appendix F: Frame Relay Firmware Version
IP Map/IARP
Write security: 3, Read security: 5
When this is set to Yes (def), the Express L128/L128T will send Inverse ARP
packets in order to determine the IP address on the other end of the virtual cir-
cuit. If the IARP is responded to, a route is placed in the IP route table. A set-
ting of No means that the route address is to be assigned statically using the
IP Map/Far-End IP Address parameter. The Express L128/L128T will always
respond to Inverse ARP requests.
IP Map/Far-End IP Address
Write security: 3, Read security: 5
This is the IP address of the device on the other end of the virtual circuit.
When this DLCI becomes active, the Express L128/L128T will add a route in
the IP routing table.
IP Map/IP Netmask
Write security: 3, Read security: 5
The IP network mask to apply to the Far-End IP Address and Link IP Address
is specified here.
IP Map/Link IP Address
Write security: 3, Read security: 5
The virtual circuit may require an IP address to be specified at this DLCI inter-
face. This is called a numbered interface. This address is used by the Express
L128/L128T to respond to Inverse ARP requests. If this IP address is left as
0.0.0.0, the link is treated as unnumbered and the Express L128/L128T re-
sponds to the Inverse ARP with its Ethernet IP address.
IP Map/RIP Protocol
Write security: 3, Read security: 5
The RIP protocol can be specified per DLCI. The possible selections are Off
(meaning no RIP packets are listened to or sent), V1 (def) (which is RIP version
1) or V2 (which is RIP version 2).
152
Express L128/L128T User Manual
61202.070L1-1
Advertisement
Table of Contents
