Basic Job Build Tasks
•
The Build button will display a green checkmark icon indicating that the build completed
successfully.
Removing a Part from the Printer
To remove a part from the printer:
1. Open the oven door.
2. Turn the vacuum control system Off to release the build sheet.
3. Remove the build sheet from the platen.
4. Carefully remove the part from the build sheet.
If the build was terminated abnormally, a warning indicator will be displayed on the
screen. See
"Build Abort Errors" (page 241)
and resolution instructions.
Figure 26: Print Successful Dialog
Warning: Hot Surface Hazard
Always wear proper heat protective gloves and clothing when handling items inside
the oven, as surfaces within the oven can be very hot.
Caution:
Do not attempt to remove a part from the build sheet while the build sheet is on the
platen. Damage to the platen or platen level may occur.
© Copyright 2021 Stratasys. All rights reserved.
After a Build is Complete
for a list of abort related warnings/errors
Page 133