Installing The Horizontal Stabilizers; Preparing The Wings - BVM F-15B Assembly And Operating Manual

Installing the Horizontal Stabilizers

•
Use a Phillips head screw driver to remove
the (4) screws holding the cover plate in
place.
•
The elevator clamping block uses (2) 8/32
bolts. A 9/64 wrench is required to tighten
these.
NOTE: Final adjustment should be done with the
radio on.
Use the provided Template to set the neutral point
for the Elevator This will be used later as well for
surface throws.

Preparing The Wings

•
On the BVM demo model we moved the
aileron linkage to a lower hole on the servo
to improve resolution. The flaps do not need
to be changed.
BVM ®2021 5 April 2021