Cable Routing For The Communication Interfaces - Delta DPH Series User Manual

No. Item
❶
RESET
MODBUS
❷
(RS-485 Port)
❸
BMS
❹
DISPLAY
❺
EMS/ CONSOLE
❻
(USB Port × 2)
❼
(Network Port)
4.3

Cable Routing for the Communication Interfaces

Regarding cable routing for the communication interfaces, follow Step 1 ~ Step 5 stated in
5.4.3.1 Single Input (Single Unit).
NOTE:
1. Please follow local regulations to install a suitable conduit and bushing for
cable protection.
2. Please refer to national and local electrical codes for acceptable cable sizes.
3. Only when 5.3 UPS Installation is completed can you perform wiring.
4. Cable ties are user-supplied and the quantity depends on on-site
requirements.
Modulon DPH Series
Press the RESET button to restart the LCD.
1. Provides MODBUS RTU communication service.
2. Connects to a user-supplied monitoring system.
Reserved.
Before shipment, the DISPLAY port has been
connected.
Connects to a user-supplied environmental monitoring
system or Delta EnviroProbe 1000 (optional).
There are two USB ports. Connect a user-supplied
USB flash drive to any of the USB ports to (1) upgrade
the UPS and LCD's firmware and (2) download event
logs.
1. Provides network communication service (including
SNMP, MODBUS TCP, HTTP, HTTPS, etc.).
2. Connects to a user-supplied monitoring system.
38
Description