Advertisement
PFT50
STEP 5
BE CAREFUL TO ASSEMBLE ALL COMPONENTS
IN THE SEQUENCE THAT THEY ARE PRESENTED.
NOTE:
finger tighten all hardware FIRST. wrench tighten all hardware
at the END of this step. some components may be pre-assembled.
nylon lock nuts will not fully screw onto bolts, must wrench tighten.
5A. Route Cable (#5) while installing Pulleys (#8) on the left side
of the machine as shown in step 5 drawing using:
5 - (#19) M10X45mm Hex Head Bolt
2 - (#22) M10X100mm Hex Head Bolt
14 - (#27) M10 Washer
7 - (#29) M10 Nylon Lock Nut
4 - (3) Bushing
5B. Repeat the previous Step (5A) on the other side of the machine.
20
Advertisement
