Advertisement
PFT50
STEP 4
BE CAREFUL TO ASSEMBLE ALL COMPONENTS
IN THE SEQUENCE THAT THEY ARE PRESENTED.
NOTE:
finger tighten all hardware FIRST. wrench tighten all hardware
at the END of this step. some components may be pre-assembled.
nylon lock nuts will not fully screw onto bolts, must wrench tighten.
4A.
attach Lat Bar (H) to uprights (E & F) using:
4 - (#21) M10X70mm Hex Head Bolt
8 - (#27) M10 Washer
4 - (#29) M10 Nylon Lock Nut
3B.
attach Double Pulley (K) to Handle (J) on each side using:
2 - (#18) M12X175mm Hex Head Bolt
4 - (#26) M12 Washer
2 - (#28) M12 Nylon Lock Nut
4 - (#2) BUSHING
Note: Do not tighten down bolts to hard, make sure that the Double
Pulley is able to swivel.
18
Advertisement
