Advertisement
PFT50
STEP 3
BE CAREFUL TO ASSEMBLE ALL COMPONENTS
IN THE SEQUENCE THAT THEY ARE PRESENTED.
NOTE:
finger tighten all hardware. some components may be pre-assembled.
3A.
Install Guide Rods (Y) into the holes of the Base Frame (C).
3B.
Install Rubber Donuts (#15) and slide to the bottom of the
Guide Rods (Y)
3C. Insert all Weight plates (#41) onto Guide Rods (Y)
3D. Install Top Plate (#30) & Selector Rod Assembly (N) onto
Guide Rods (Y).
3E. Install Weight Plate Pin (#32) using the key ring end through
the Pulley Bracket (M)
3F. Install M12 Hex Nut (#35), M12 Lock Washer (#36) & Pulley
Bracket (M) onto Selector Rod (N).
3G. Insert Guide Rods (Y) into Support Beam (G) and attach Support
Beam (G) to both Left & Right Uprights (E & F) using:
4 - (#20) M10X60mm Hex Head Bolt
8 - (#27) M10 Washer
4 - (#29) M10 Nylon Lock Nut
16
Advertisement
