Updating Software; Specifi Cations - Bush HA42U5232MEKB Instruction Manual

Other information
Helpful technical information

Updating Software

There are a number of ways in which the software on your set can be updated. When your set is produced, the
software installed will ensure the correct operation of the set, this may need to be updated should improvements be
made and this is normally carried out automatically if the set is connected to the internet.
Note: For further support with software updates, contact our technical support team or refer to the 'Product
Support' section of the website. If the television is using the newest software available it will not attempt to update
the software.
If your set is outside of guarantee and the installation of the software causes a diff erent issue you may be liable for
a chargeable repair service. The reason for this is because you may have a fault which can cause corruption on
one of the boards when installing the software. This could result in your unit locking into SAFE mode whereby it is
stuck in standby. This is not a fault with the software, this would be caused by an existing faulty board that would
have required a repair.
Specifi cations
Energy Effi ciency Class (SDR)
Power consumption (SDR)
Energy Effi ciency Class (HDR)
Power consumption (HDR)
Screen resolution (pixels)
Screen Size (diagonal)
RF
Inputs
Sound Outputs
Speaker/ Amplifi er Watts (RMS)
Voltage and power consumption
Dimensions including stand (mm)
Net weight (Kgs)
Wall Mounting
If you still require further assistance, call one of our experts on 0345 604 0105, a Bush enquiry line. (Calls are charged at the standard rate of your network provider).
HA42U5232MEKB
75 ohm Antenna / Analog / DVB / Satellite
3 x HDMI, 3 x USB, SD Card Reader, 1 x RJ45 LAN/Ethernet,
1 x Component/YPbPr, 1 x Composite/Video & L/R Audio shared for Composite/Video & Component/YPbPr
1 x Digital Optical Audio output, 1 x 3.5mm Headphone
63/75/95W (eco mode/std/max)
G
63 W
G
74 W
3840 x 2160
106 cm / 42 inches
2 x 10 / 2 x 8
AC 220V ~ 240V; 50Hz
(<0.5W in Standby)
953W x 579H x 188D
6.7
VESA 200 x 200 (mm)
Other information 83