Stand Installation; Detaching The Stand - Bush HA42U5232MEKB Instruction Manual

Getting to know your TV
You'll be up and running in no time

Stand installation

To complete the stand installation, you will require a cross head screw driver and the supplied screws.
4 x M(4x16)
1
fi g 1) Place the TV set on a fl at and clean surface with the
panel facing downwards to avoid damage, then fi x the
stand feet shown.

Detaching the stand

To detach the stand, place the TV set on a fl at and clean surface with the panel facing downwards to avoid damage.
Please remove the 4 screws highlighted then remove the stand feet from the rear of the TV set.
Helpful advice for fi rst time stand installation
a) Ensure the cross head screw driver tip fi ts correctly into the head of the screw and that it is not too big or small.
b) Screw in all screws individually and partially before tightening all of the screws fully.
If you require any technical guidance or fi nd that your TV is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
Getting to know your TV
16
R
L
or online at www.bush-support.co.uk.
2
fi g 2) Secure the stand feet to the underside of the TV set
using the screws provided.
3
4
R
1
2
L
4 x
3
4
R
1
2
L
4 x