Bush HA42U5232MEKB Instruction Manual page 92

Product support
Help is always at hand
Troubleshooting Guide
The remote control does not operate.
Check if the TV is working properly
Press the power button on the television to determine if the problem is with the remote control or not.
Check if the remote control is working properly
Point the remote control at the remote control sensor located at the front of the television.
Keep the remote control sensor area clear from obstacles.
Fluorescent light can interfere with remote control operation; try turning off any fl uorescent light.
Check that the orientation of each battery matches the positive (+) and negative (-) symbols in the battery
compartment.
Battery power may be low. Remove the remote control cover and replace the batteries with new ones.
It is not possible to control the Google Assistant with voice
To use your voice to control the Google Assistant, you need a remote control which has a
television must be paired to this remote control.
If your remote is not paired with the TV yet, please follow the steps below:
Press the button on the remote control.
Follow the on-screen instructions to pair the remote control with the television.
Select the detected remote control shown on the screen and press [OK].
Once paired, the pairing screen will disappear.
Pairing the remote
If during the fi rst-time installation process the remote was not paired or skipped, then follow the process below to pair
your remote with the television:
Turn the set on.
Go to Settings > Remotes and Accessories or press the
Now press and hold the [LEFT ARROW] and [HOME] buttons on the remote control at the
HOME HOME
same time.
The LED indicator on the remote control will start to fl ash.
Select your remote control from the list shown on the television screen and press [OK] on the
remote control.
Once paired, the pairing screen will disappear.
Note: This process will only have to be completed if the remote control has not been paired.
Once paired, when the
voice functionality.
When your remote control is paired, it uses Bluetooth to transmit information. This means that the remote does not
need to be pointed towards the set to work.
If you require any technical guidance or fi nd that your TV is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
92 Product support
button is pressed, it will open the Google Assistant screen on the television and activate
or online at www.bush-support.co.uk.
button on the remote control.
button, in addition the