Digital Television, Freeview; Tuning In Channels - Bush HA42U5232MEKB Instruction Manual

Advanced features
Getting the most from your TV
Digital Television, Freeview and Freeview Play
To watch television programmes via Antenna, Cable or Satellite, press the [HOME] button, select Apps from the Home
Page, and select Live television from the apps list. You can also enter the digital television mode by pressing the [TV]
button on the remote control.
Should your set not be tuned into a digital signal, follow the instructions as below:
Tuning in Digital Channels
It is possible to tune into terrestrial, cable and satellite digital television signals on your television set. To do this, follow
the instructions given below for each type of signal input.
Terrestrial
Before tuning terrestrial channels, ensure the television is in TV mode:
Press the [HOME] button, then select Settings > Channel > Channel installation mode.
Select option Antenna.
To start automatic channel scan press the [HOME] button, then select Settings > Channel > Channels > Channel scan.
After tuning into Freeview, you may be presented with a choice of regions; this is dependent upon your location and
the number of transmissions received. Normally there will only be one transmitter:
Region 1 Country
Region 2 Transmitter Location
Region 3 Local News variation
Terrestrial
Receiving cable digital broadcast;
Before tuning cable channels, ensure the television is in cable mode:
Press the [HOME] button, then select Settings > Channel > Channel installation mode.
Select option Cable.
To start automatic channel scan, press the [HOME] button, then select Settings > Channel > Channels > Channel
scan.
Satellite
Before tuning satellite channels, ensure the television is in satellite mode:
Press the [HOME] button, then select Settings > Channel > Channel installation mode.
Select option Preferred Satellite if you want to tune one of satellites preferred in your country.
Select option General Satellite to get possibility to tune any satellite.
To start automatic channel scan, press the [HOME] button, then select Settings > Channel > Channels > Satellite Re-
scan.
Choose the Satellite you wish to tune.
Select Scan and press [OK].
Note: You can only tune into one type of digital television signal.
If you require any technical guidance or fi nd that your TV is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
72 Advanced features
or online at www.bush-support.co.uk.