Table of Contents
Advertisement
The programmed functions are grouped on the foot pedal.
Foot pedal
(for model 2800-30)
Presentation
Safety note
When using pre-programmed positions (reception, QE1, QE2),
do not leave the patient on the chair unattended.
QE = Quick Exam
Setting the leg plate tilt RIGHT
(Extended)
Setting the tilt using press-and-hold
Setting the height (Up)
Setting the height using press-and-hold
Setting the leg plate tilt LEFT
(Extended)
Setting the tilt using press-and-hold
Saving programmed positions
The QE1 and QE2 buttons are factory default settings, and can be modified. To save a
New position on the QE1 or QE2 button, just move the chair to the desired position, then
Press the M and QE1 (or QE2) buttons simultaneously for 10 seconds.
Remark:
This foot control operates with two (2) LR03 - AAA Alkaline 1.5V batteries.
In the event of malfunction, these batteries will have to be replaced.
(See page 29: REPLACING USED BATTERIES IN THE FOOT PEDAL
User Manual
QE2 position
Position fully
configurable by
the user
Programming the
controls
Memorisation button by
press-and-hold
QE1 position
Position fully
configurable by
the user
Setting the leg plate tilt RIGHT
(Retracted)
Setting the tilt using press-and-hold
Setting the height (Down)
Setting the height using press-and-hold
Setting the leg plate tilt LEFT
(Retracted)
Setting the tilt using press-and-hold
Welcome Position
Standard position for getting on
and off the chair
(H: 55cm)
One press (impulse).
15
Advertisement
Table of Contents
