Kessel Aqualift Basic Mono Installation And Operating Instructions Manual page 39

LED
Green rot Orange orange
(1) (2) (3)
Potential-free contact is activated (Art.No. 80074 must have been activated and connected beforehand)
1
The battery monitoring is only active if a battery was connected at the time of commissioning.
2
If the error re-occurs, contact customer service
3
Acknowledge alarm
If a condition arises that triggers an alarm, this will be indi-
cated through the illumination of the alarm LED (2) and, if
applicable, one of the other LEDs. After rectifying the cause
of the alarm, the alarm can be acknowledged by pressing the
button (7).
Switching off the alarm tone
Press button (7) 1x
Acknowledge alarm
Press and hold button (7) > 3 seconds.
The alarm indicator goes out, the alarm is acknowledged.
016-207_01
Acoustic
signal PFC
(interval)
(4)/(5)
Yes
- -
Installation and operating instructions
Description
1
Alarm level exceeded
Maximum switch-
ing cycles exceeded
Measure
Wait until the level drops
below the alarm level again
Acknowledge alarm
and replace control unit
39 / 128