Table of Contents
Advertisement
LaserLT-60 and LaserLT-100 Large-Display Weight Indicators
4.2
Quick Setup Menu
Press
and
type
Press
and
nChan
Press
and
Chan
Press
and
DIV.DEC
Press
,
CAPAC
Press
,
CEL.CAP
Press
,
CEL.SEN
Press
,
DEAD.LD
Quick calibration of zero.
0.CALIB
For new acquisition of zero, with scale empty. Establishes new zero reference.
ZERo
Apply calibration weight. Press
SPAN
Check the load cell signal in millivolts.
ADC.uV
AN.oUT
INPUTS
oUTPUT
485
When settings are complete pres
Note
Weigh mode. Pressing any other key exits the setup and discards changes.
4.2.1
Default Factory Calibration
The instrument is shipped with the following default calibration settings:
• Capacity – 10,000 lb
• Load cell sensitivity – 2.000 mV/V
• Division – 1
See
Table 4-4 on page 20
Note
www.RiceLake.com
16
Visit our website
to set channel type ind.ch, transm, or dep.ch.
to select number of channels.
to select channel to calibrate.
to set decimals and minimum division.
and
to set the scale capacity.
and
to set the total capacity of the load cells.
and
to set the mV/V sensitivity of the load cell.
and
to set the dead load present on the load cell.
,
and
to enter calibration weight that was applied.
chan
Select channel to be configured.
MODE
Set the analog output on net or gross weight.
Ao MAX
Set the maximum value of the analog output.
Ao ZER
Set the analog output when the scale shows zero weight.
Ao MIN
Set the minimum value of the analog output.
Set the key to be emulated by the input.
INP.01
INP.02
OUT.01
OUT.02
set.Add
Press
,
and
baud
Press
and
to set baud rate.
Figure 4-1. Quick Setup Menu
s
until the indicator displays
to return indicator to default settings.
Set the output normal state.
No/NC
FUNC
to set number of additional units.
. Press
SAVE?
GRoS
Setpoint on the gross weight.
NoNE
Disabled.
Setpoint on the net weight.
NET
to save set up and return to
Advertisement
Table of Contents
