Safety Notes; Transport, Storage And Packaging - oventrop Regusol Installation And Operating Instructions For The Specialised Installer

2 Safety notes

2.1 Correct use
Safety in operation is only guaranteed if the solar
station is used correctly.
The solar station is designed for the connection of
the storage cylinder to the collector.
Any use of the solar station outside the above
applications will be considered as non-compliant and
misuse. Claims of any kind against the manufacturer
and/or his authorised representatives due to damages
caused by incorrect use cannot be accepted.
The observance of the installation and operating
instructions is part of the compliance terms.
2.2 Possible dangers at the installation location and
during transport
The case of an external fire has not been taken into
consideration when constructing the solar station.
!
WARNING
Heavy solar station!
Risk of injury! Suitable transport and lifting
devices are to be used. Wear suitable protective
clothing (e.g. safety shoes) during installation and
use safety devices. External components like
handwheels or pressure test points must not be
misused for the absorption of external forces, e.g.
as connection point for lever tools etc.
Hot and cold surfaces!
Risk of injury! Do not touch the solar station
without safety gloves. It may get very hot or cold
during operation.
Sharp edges!
Risk of injury! Only touch with safety gloves,
Threads, bore holes and edges are sharp.
Small components!
Risk of ingestion! Store and install the
components of the solar station out of reach of
children.
Allergies!
Health hazard! Do not touch the solar station and
avoid any contact if allergies against the used
materials are known.
10
2.3 Installation, initial operation, maintenance
Installation, initial operation, maintenance and repairs
have to be carried out by authorised and qualified
tradesmen.
(EN 5011 part 1 and VDE 1000 part 10 for work on
electrical appliances).
!
WARNING
If the collector surface is heated up by hot water
returning from the storage cylinder, the permissible
excess operating pressure in the pipework
between the storage cylinder and the solar station
can be exceeded
– Once filling and flushing has been completed, all
ball valves in the solar station (return ball valve
and the balancing valve) and in the collector
circuit (e.g. filling and flushing device) must be
opened again
– All ball valves must be in the open position during
operation
– The boiler must be switched off during
maintenance or repair.
– The connection between the storage cylinder
and solar station must be protected by an
additional safety valve and/or a diaphragm
expansion tank
3 Transport, storage and
packaging
3.1 Transport inspection
Upon receipt check delivery for any damages caused
during transit and for completeness.
Any damage must be reported immediately upon
receipt.
3.2 Storage
The solar station must only be stored under the
following conditions:
– Do not store in open air, keep dry and free from
dust.
– Do not expose to aggressive fluids or heat
sources.
– Protect from direct sunlight and mechanical
agitation.
– Storage temperature: –20°C up to +60°C,
max. relative humidity of air: 95 %
3.3 Packaging material
Packaging material is to be disposed of environmen-
tally friendly.