Chapter 2 Connections And Controls; Rear Panel - Datavideo HDR-1 Instruction Manual

Chapter 2
2.1

Rear Panel

Connections and Controls
DC IN
DC in socket connects the supplied 12V / 19W PSU. The
connection can be secured by screwing the outer
fastening ring of the DC In plug to the socket.
Power Bank IN
Connect an external portable USB power supply to
POWER BANK IN port. The connected external portable
USB power supply will start to provide power to the
HDR-1 when the DC power supply fails.
The HDR-1 with the USB thumb drive plugged in requires
approximately 1000mA of current. Ideally, if the power
bank capacity is 100mAh, it should be able to last for 1
hour when the DC power is disconnected from the HDR-
1. However, there is also some power loss to be taken
into consideration so in reality, the maximum transfer
rate is less than 1000mAh and the power bank should
last less than an hour.
When connecting the DC power and the power bank at
the same time, the Power Bank IN port will drain the
power bank at a rate of 100mAh. Ideally, if the power
bank capacity is 100mAh, the power bank should be able
to sustain the device operation for 10 hours. However,
there is also some power loss to be taken into
consideration so in reality, the transfer rate is less than
1000mAh and the power bank should last less than 10
hours.
9