Banner Q5X Quick Start Manual page 8

When in mode,
CH2) or (-)(MODE) are pressed, but
When in mode,
and release (+)(CH1/CH2) or (-)(MODE). To enter TEACH mode, press the (SELECT)(TEACH) button and hold for longer than 2
seconds.
To enter mode, hold
and pressing four times unlocks the sensor from either lock mode and the sensor displays
Averaging
Use this menu to set the number of measurements that are averaged together for the analog output. Increasing the averaging
improves repeatability, but increases the total response speed. The default is 16. The filter can be set to 1, 2, 4, 8, 16, 32, 64, 128,
256, or 512. Use the table to determine the total response speed.
Table 2: Response Speed (ms)
Base
Measurement Rate
1
0.5 ms 0.5
1.0 ms 1
2.0 ms 3
3.0 ms 5
5.0 ms 10
Note: The Q5X uses a dynamic measurement rate, so these response times are worst-case.
8
displays when the (SELECT)(TEACH) button is pressed. The switch point displays when (+)(CH1/
displays if the buttons are pressed and held.
displays when (-)(MODE) is pressed and held. To access the manual adjust options, briefly press
and press four times. To enter
2 4 8
1.5 3 7
3 5 11
5 9 20
8 15 30
15 25 45
www.bannerengineering.com - Tel: + 1 888 373 6767
Q5X Laser Triangulation Sensor with Analog Outputs
mode, hold and press
Filter Setting
16 32 64
13 26 50
20 45 90
40 80 150
55 110 220
85 170 340
Table 3: Lateral Entry Response
Base Measurement Rate
(ms)
0.5
1.0
2.0
3.0
5.0
When lateral entry needs to be considered, the lateral entry
response is added to calculate the total response time.
seven times. Holding
.
128 256 512
100 200 400
160 320 650
300 600 1200
420 840 1680
680 1350 2270
Lateral Entry Response (ms)
3
5
15
25
50
P/N 219603 Rev. A