Using The Multimeter Mode - Casio E-CON2 Use Manual

5 Using the MULTIMETER Mode

You can use the Channel Setup screen (page 3-2) to configure a channel so that EA200
MULTIMETER Mode sampling is triggered by a calculator operation.
To use the MULTIMETER Mode
u u u u u
1. Connect the calculator and EA-200, and connect the sensors you want to the applicable
EA-200 channels.
2. From the Advanced Setup menu (page 3-1), use the Channel Setup screen (page 3-2) to
configure sensor setups for each channel you will be using.
3. After configuring the sensor setups, press w to return to the Advanced Setup menu
(page 3-1), and then press 2(MULT).
• This starts sampling in the EA-200 MULTIMETER mode and displays a list of sample
values for each channel.
4. To end MULTIMETER mode sampling, press the A key. After "Break" appears on the
display, press i.
• Displayed sample data is refreshed at 0.5-second intervals.
• Do not connect sensors to any other channels except for those you specified in step 2.
• You do not need to select "None" for the sensor selection setting of channels that you do
not select in step 2.
• Data sampled in the MULTIMETER mode is not saved in memory.
5-1
Using the MULTIMETER Mode
20021201